Hdlc Interface Command Set - ADTRAN AOS Version R10.1.0 Command Reference Manual

Command Reference Guide
HDLC I
NTERFACE
To create a virtual high level data link control (HDLC) interface and/or activate the HDLC Interface
Configuration mode, enter the interface hdlc command at the Global Configuration mode prompt. For
example:
>enable
#configure terminal
(config)#interface hdlc 1
(config-hdlc 1)#
The following commands are common to multiple command sets and are covered in a centralized section
of this guide. For more information, refer to the sections listed below:
cross-connect on page 67
description <text> on page 70
do on page 71
end on page 72
exit on page 73
interface on page 74
shutdown on page 82
All other commands for this command set are described in this section in alphabetical order.
alias link "<text>" on page 2310
bandwidth <value> on page 2311
bridge-group <value> on page 2312
bridge-group <number> vlan-transparent on page 2313
crypto map <name> on page 2314
dial-backup commands begin on page 2316
dynamic-dns on page 2333
fair-queue on page 2335
hold-queue <value> out on page 2336
ip commands begin on page 2337
ipv6 dhcp relay destination <ipv6 address> on page 2375
ipv6 policy-class <ipv6 acp name> max-sessions <number> on page 2376
keepalive <value> on page 2377
lldp receive on page 2378
lldp send on page 2379
max-reserved-bandwidth <value> on page 2381
media-gateway ip on page 2382
packet-capture <name> on page 2383
60000CRG0-35E
C S
OMMAND ET
Copyright © 2012 ADTRAN, Inc.

HDLC Interface Command Set

2308