L2Tp Unlock-Test Destination - Juniper JUNOSE SOFTWARE 11.2.X - XML MANAGEMENT PROTOCOL GUIDE 6-30-2010 Command Reference Manual
Software for e series broadband services routers command reference a to m
Hide thumbs
Also See for JUNOSE SOFTWARE 11.2.X - XML MANAGEMENT PROTOCOL GUIDE 6-30-2010:
- Manual (282 pages)
Table of Contents
Advertisement
JunosE 11.2.x Command Reference Guide A to M
l2tp unlock-test destination
Syntax
Release Information
Description
Options
Mode
1190
l2tp unlock-test destination { destinationName |
[ virtual-router vrName ] ip ipAddress }
Command introduced in JunosE Release 7.2.0.
Forces L2TP to disregard any remaining lockout time and immediately begin the lockout
test procedure for the specified destination. If lockout testing is not enabled, this command
immediately unlocks the destination. There is no no version.
destinationName—Name of the L2TP destination
vrName—Name of the virtual router on which the destination exists
ipAddress—IP address of the destination
Privileged Exec (at privilege level 10 or higher)
Copyright © 2010, Juniper Networks, Inc.
Advertisement
Table of Contents
