L2Tp Unlock Destination - Juniper JUNOSE SOFTWARE 11.2.X - XML MANAGEMENT PROTOCOL GUIDE 6-30-2010 Command Reference Manual
Software for e series broadband services routers command reference a to m
Hide thumbs
Also See for JUNOSE SOFTWARE 11.2.X - XML MANAGEMENT PROTOCOL GUIDE 6-30-2010:
- Manual (282 pages)
Table of Contents
Advertisement
l2tp unlock destination
Syntax
Release Information
Description
Options
Mode
Copyright © 2010, Juniper Networks, Inc.
l2tp unlock destination { destinationName | [ virtual-router vrName ] ip ipAddress }
Command introduced in JunosE Release 7.2.0.
Forces L2TP to immediately unlock the specified L2TP destination and return the
destination to the available state. Any remaining lockout time and the lockout test setting
(if configured) are not taken into account. There is no no version.
destinationName—Name of the L2TP destination
vrName—Name of the virtual router on which the destination exists
ipAddress—IP address of the destination
Privileged Exec (at privilege level 10 or higher)
Chapter 12: L Commands
1189
Advertisement
Table of Contents
