Renault Laguna III Manual page 2106

FRONT AXLE COMPONENTS
Front brake calliper: Removal - Refitting
a Undo the brake hose union (3) slightly on the brake
calliper.
a Remove:
- the plugs at the end of the guide pins,
- the guide pin bolts (4) ,
- the brake pads,
- the brake pipe union (3) on the brake calliper,
- the brake calliper,
REFITTING
I - REFITTING PREPARATION OPERATION
a Check the condition of the calliper gaiter.
a Check the condition of the calliper piston and re-
place it if there are deep scratches or cracks.
a Replace any faulty parts (see 31A, Front axle com-
ponents, Front brake calliper: Repair, page 31A-
10) .
a Clean using a wire brush and BRAKE CLEANER
(see Vehicle: Parts and consumables for the re-
pair) (MR 415, 04B, Consumables - Products):
- the calliper supports,
- the callipers,
- the guide pin bolts.
122720
a Push the piston fully into its housing using the tool
(Fre. 1190-01) part number (77 11 223 715).
II - REFITTING OPERATION FOR PART
CONCERNED
a Fit the inner brake pad with the lugs (5) in the calliper
piston.
a Screw the brake pipe union onto the calliper.
a Refit:
- the outer brake pad on the calliper mounting,
31A-8
31A
103115
114436