Renault Laguna III Manual page 2102

FRONT AXLE COMPONENTS
Front brake pads: Removal - Refitting
REFITTING
I - REFITTING PREPARATION OPERATION
a Measure the thickness of the pads and then com-
pare them to the minimum values (see 30A, Gener-
al information, Brake: Specifications, page 30A-
16) .
a Clean using a wire brush and BRAKE CLEANER
(see Vehicle: Parts and consumables for the re-
pair) (04B, Consumables - Products):
- the calliper supports,
- the callipers,
- the guide pin bolts,
- the brake discs.
a Push the piston fully into its housing using the tool
(Fre. 1190-01) part number 77 11 223 715.
II - REFITTING OPERATION FOR PART
CONCERNED
a Fit the inner brake pad with the lugs (4) in the calliper
piston.
a Refit:
- the outer brake pad on the calliper mounting,
- the calliper with the inner brake pad on the calliper
mounting,
- the guide pin bolts.
a Torque tighten the guide pin bolts (28 N.m).
a Refit:
103115
- the plugs at the end of the guide pins,
- the retaining spring on the front end of the calliper
using a large flat-blade screwdriver.
a Set the wheels straight ahead.
a Attach the brake hose to the shock absorber.
III - FINAL OPERATION
a Refit the front wheels (see 35A, Wheels and tyres,
Wheel: Removal - Refitting, page 35A-1) .
IMPORTANT
To avoid any accident, bring the pistons, brake
pads and brake discs into contact by depressing
the brake pad several times.
31A-4
31A
114436