Renault Laguna III Manual page 2111

FRONT AXLE COMPONENTS
Front brake calliper mounting: Removal - Refitting
REFITTING
I - REFITTING PREPARATION OPERATION
a Clean using a wire brush and BRAKE CLEANER
(see Vehicle: Parts and consumables for the re-
pair) (04B, Consumables - Products):
- the calliper mounting,
- the calliper,
- the guide pin bolts,
- the hub carrier.
a Always replace the calliper support bolts.
II - REFITTING OPERATION FOR PART
CONCERNED
a Refit:
- the calliper mounting,
- the calliper mounting bolts.
a Torque tighten the calliper mounting bolts (105
N.m).
III - FINAL OPERATION
a Refit the brake calliper with the inner brake pad on
the calliper mounting.
a Torque tighten the guide pin bolts (28 N.m).
a Refit:
- the plugs at the end of the guide pins,
- the retaining spring on the front end of the calliper
using a large flat-blade screwdriver.
IMPORTANT
T o avoid any accident, bring the pistons, brake
pads and brake discs into contact by depressing
the brake pad several times.
a Set the wheels straight ahead.
a Attach the brake hose to the shock absorber.
a Refit the front wheel (see 35A, Wheels and tyres,
Wheel: Removal - Refitting, page 35A-1) .
31A-13
31A