Configuring Radius Accounting Servers - H3C S3100-52P Operation Manual

Operation Manual – AAA – RADIUS – HWTACACS
H3C S3100-52P Ethernet Switch

1.4.3 Configuring RADIUS Accounting Servers

Table 1-14 Configure RADIUS accounting servers
Enter system view
Create
scheme and enter its view
Set
accounting-optional
switch
Set the IP address and
port number
primary
accounting server
Set the IP address and
port number
secondary
accounting server
Enable
request buffering
Set the maximum number
of transmission attempts
of
stop-accounting request.
Set the maximum allowed
number
real-time
failures
Operation
system-view
a RADIUS radius
radius-scheme-name
the
accounting optional
of the primary
RADIUS ip-address [ port-number ]
of the secondary
RADIUS ip-address [ port-number ]
stop-accounting
stop-accounting-buffer
enable
retry
a buffered retry-times
retry
of continuous
realtime-accounting
accounting
retry-times
Chapter 1 AAA & RADIUS & HWTACACS
Command
scheme
accounting
accounting
stop-accounting
1-24
Configuration
Description
—
Required
By default, a RADIUS
scheme named "system"
has already been created
in the system.
You must select one from
the two operations.
By default,
accounting-optional
switch is closed, that is,
accounting is required.
By default, the IP address
and UDP port number of
the primary accounting
server are 0.0.0.0 and
1813.
Optional
By default, the IP address
and UDP port number of
the secondary accounting
server are 0.0.0.0 and
1813.
Optional
By default,
stop-accounting request
buffering is enabled.
Optional
By default, the system
tries at most 500 times to
transmit a buffered
stop-accounting request.
Optional
By default, the maximum
allowed number
continuous real-time
accounting failures is five.
If five continuous failures
occur, the switch cuts
down the
connection.
the
of
user