Nas-Ip (Radius Scheme View); Primary Accounting (Radius Scheme View) - H3C S5120-SI Series Command Reference Manual

nas-ip (RADIUS scheme view)

Syntax
nas-ip ip-address
undo nas-ip
View
RADIUS scheme view
Default Level
2: System level
Parameters
ip-address: IPv4 address in dotted decimal notation. It must be an address of the device and cannot be
0.0.0.0, 255.255.255.255, a class D address, a class E address, or a loopback address.
Description
Use the nas-ip command to specify the IP address for the device to use as the source address of the
RADIUS packets to be sent to the server.
Use the undo nas-ip command to restore the default.
By default, the source IP address of a packet sent to the server is that configured by the radius nas-ip
command in system view.
Note that:
Specifying a source address for the RADIUS packets to be sent to the server can avoid the
situation where the packets sent back by the RADIUS server cannot reach the device as the result
of a physical interface failure. The address of a loopback interface is recommended.
The nas-ip command in RADIUS scheme view is only for the current RADIUS scheme, while the
radius nas-ip command in system view is for all RADIUS schemes. However, the nas-ip
command in RADIUS scheme view overwrites the configuration of the radius nas-ip command.
You can use the commands to change the setting only when no user is using the RADIUS scheme.
Related commands: radius nas-ip.
Examples
# Set the IP address for the device to use as the source address of the RADIUS packets to 10.1.1.1.
<Sysname> system-view
[Sysname] radius scheme test1
[Sysname-radius-test1] nas-ip 10.1.1.1

primary accounting (RADIUS scheme view)

Syntax
primary accounting ip-address [ port-number ]
undo primary accounting
2-11