Configuring To Output System Information To The Console - H3C S5500-SI Series Operation Manual

Operation Manual – Information Center
H3C S5500-SI Series Ethernet Switches
Output direction
Note:
NMS = Network Management Station
Note:
Configurations for the six output directions function independently and take effect only
after the information center has been enabled.

1.2.1 Configuring to Output System Information to the Console

I. Configuring to output system information to the console
Follow these steps to configure to output system information to the console:
Enter system view
Enable information center
Name the channel with a
specified channel number
Configure
through
information can be output
to the console
Configure the source of
the output information
Configure the format of
the time stamp
Information channel No.
To do...
system-view
info-center enable
info-center
channel-number
channel-name
the channel
info-center
which system channel
{
channel-name }
info-center
{ modu-name | default }
channel
{
channel-name } [ debug
{ level severity | state
state }* | log { level
severity | state state }* |
trap { level severity |
state state }* ]*
info-center
{ log | trap | debugging }
{ boot | date | none }
Chapter 1 Information Center Configuration
Use the command...
channel
name
console
channel-number
source
channel-number
timestamp
1-5
Default channel name
Remarks
—
Optional
Enabled by default
Optional
Refer to Table 1-3 for
default channel names
Optional
System information
output to the console by
|
default with channel 0 as
the default channel
|
Required
Optional
By default, the time stamp
for log and
information is date, and
that for debugging
information is boot.
is
trap