Passive-Interface (Ospf) - Allied Telesis x310-26FT Command Reference Manual

OSPF C
OMMANDS
- (OSPF)
PASSIVE INTERFACE

passive-interface (OSPF)

Overview Use this command to suppress the sending of Hello packets on all interfaces, or on
a specified interface. If you use the passive-interface command without the
optional parameters then all interfaces are put into passive mode.
Use the no variant of this command to allow the sending of Hello packets on all
interfaces, or on the specified interface. If you use the no variant of this command
without the optional parameters then all interfaces are removed from passive
mode.
passive-interface [<interface>][<ip-address>]
Syntax
no passive-interface [<interface>][<ip-address>]
Mode Router Configuration
Usage Configure an interface to be passive if you wish its connected route to be treated
as an OSPF route (rather than an AS-external route), but do not wish to actually
exchange any OSPF packets via this interface.
Examples To configure passive interface mode on interface vlan2, enter the following
commands:
awplus(config)#
awplus(config-router)#
To configure passive interface mode on all interfaces, enter the following
commands:
awplus(config)#
awplus(config-router)#
To remove passive interface mode on interface vlan2, enter the following
commands:
awplus(config)#
awplus(config-router)#
To remove passive interface mode on all interfaces, enter the following
commands:
awplus(config)#
awplus(config-router)#
C613-50103-01 REV A
Parameter Description
<interface>
The name of the interface.
<ip-address>
IP address of the interface, entered in the form A.B.C.D.
router ospf 100
router ospf 100
router ospf 100
router ospf 100
Command Reference for x310 Series
AlliedWare Plus™ Operating System - Version 5.4.6-1.x
passive-interface vlan2
passive-interface
no passive-interface vlan2
no passive-interface
924