Delta AX Series Instruction Manual page 324

AX- Ser i es Mo t i o n Co n t r o l l er I n s t r u c t i o n s Ma n u a l
Programming Example

The example explains the action principle for DMC_CamWriteTappetValue by writing the tappet data of Track ID 1.

Initial setting for tappet points

Function block setting

Input 1 for uiTrackID. Refer to the figure below for the setup of IrMasterPos, PositiveMode and NegativeMode.

The tappet table before the function block is run

Track ID
1
Master axis position
100
Direction
Negative
Ch a p t er 2
Passing mode
TAPPETACTION_off
3 1 9