Display Telnet-Server Source - H3C s3600 series Command Manual

View
AUX user interface view
Parameters
7: Sets the databits to 7.
8: Sets the databits to 8.
Description
Use the databits command to set the databits for the user interface.
Use the undo databits command to revert to the default databits.
The default databits is 8.
Examples
# Set the databits to 7.
<Sysname> system-view
System View: return to User View with Ctrl+Z.
[Sysname] user-interface aux 0
[Sysname-ui-aux0] databits 7
display telnet-server source-ip
Syntax
display telnet-server source-ip
View
Any view
Parameters
None
Description
Use the display telnet-server source-ip command to display the source IP address configured for the
switch operating as the Telnet server. That is, when the switch operates as the Telnet server, the client
uses this IP address to log in to the switch.
If the source IP address or source interface is specified for the switch, this command displays the
IP address or the primary IP address of the source interface.
If neither source IP address nor source interface is specified, 0.0.0.0 is displayed. That is, as long
as there is a route between the switch and client, the client can log in to the switch using the IP
address of any Layer 3 interface on the switch.
1-5