Guidelines; Examples; Engineering Labels For Network Cables - H3C CR19000-20 Installation Manual

Figure10-8 Affixing a generic label
Adhesive side
Affixing a label to a device
Remove the device label and stick it to the device. You can stick a device label to any desired
position on the device.

Guidelines

•
When you print, write, or affix labels, keep the labels clean.
•
Do not use ink-jet printers or ink pens.
•
Affix labels with good order in alignment.
•
Avoid cable bents or other positions that might affect cable installation when you stick a label or
bundle a cable tie with a power cord identification plate.
•
Bundle cable ties at the same positions of power cords, with identification plates on the same
side.
•
The positions of "up", "down", "right" or "left" are all based on the viewpoint of the engineering
person who is working on the label.

Examples

The label examples in this document are for reference only.

Engineering labels for network cables

These labels are affixed to Ethernet cables that connect modules in a chassis.
1 2
10-6
TO:
B02 03 12
3