Table of Contents
Advertisement
RIP
IP
6 C
NG FOR
V
OMMANDS
6
SHOW IPV
RIP INTERFACE
show ipv6 rip interface
Overview
Use this command to display information about the RIPng interfaces. You can
specify an interface name to display information about a specific interface.
For information on filtering and saving command output, see the
with AlliedWare Plus" Feature Overview and Configuration
Syntax
show ipv6 rip interface [<interface>]
Mode
User Exec and Privileged Exec
Example
To display RIPng interface information, use the following command:
awplus#
Output
C613-50103-01 REV A
Parameter
Description
<interface>
The interface to display information about. For instance: vlan2.
show ipv6 rip interface
lo is up, line protocol is up
RIPng is not enabled on this interface
vlan1 is up, line protocol is up
RIPng is not enabled on this interface
vlan2 is down, line protocol is down
RIPng is not enabled on this interface
vlan3 is up, line protocol is up
Routing Protocol: RIPng
Passive interface: Disabled
Split horizon: Enabled with Poisoned Reversed
IP interface address:
2001:db8:1::1/64
2001:db8:1::2/64
Command Reference for x310 Series
AlliedWare Plus™ Operating System - Version 5.4.6-1.x
"Getting Started
Guide.
857
Advertisement
Table of Contents
