Show Ipv6 Rip Interface - Allied Telesis IE340 Series Command Reference Manual

RIP IP 6 C
NG FOR V OMMANDS
6
SHOW IPV RIP INTERFACE

show ipv6 rip interface

Overview Use this command to display information about the RIPng interfaces. You can
specify an interface name to display information about a specific interface.
For information on filtering and saving command output, see the
with AlliedWare Plus" Feature Overview and
Syntax show ipv6 rip interface [<interface>]
Mode User Exec and Privileged Exec
Example To display RIPng interface information, use the following command:
awplus#
Output Figure 27-4: Example output from the show ipv6 rip interface command
C613-50631-01 Rev A
Parameter Description
<interface>
The interface to display information about.
show ipv6 rip interface
lo is up, line protocol is up
RIPng is not enabled on this interface
vlan1 is up, line protocol is up
RIPng is not enabled on this interface
vlan2 is down, line protocol is down
RIPng is not enabled on this interface
vlan3 is up, line protocol is up
Routing Protocol: RIPng
Passive interface: Disabled
Split horizon: Enabled with Poisoned Reversed
IP interface address:
2001:db8:1::1/64
2001:db8:1::2/64
...
Command Reference for IE340 Series
AlliedWare Plus™ Operating System - Version 5.5.3-0.x
"Getting_Started
Configuration_Guide.
1099