Reset Fr Pvc; Snmp-Agent Trap Enable Fr - H3C MSR810 Command Reference Manual

Parameters
interface interface-type interface-number: Specifies an interface by its type and number. It can be a
main interface or subinterface.
• If you specify a main interface, this command clears information for the main interface and its
subinterfaces.
• If you specify a subinterface, this command clears information for the subinterface.
• If you do not specify an interface, this command clears information for all interfaces.
dlci dlci-number: Specifies a VC by its DLCI in the range of 16 to 1007. DLCIs 0 through 15 and 1008
through 1023 are reserved.
• If you specify a main interface and a VC that is not on the main interface or any of its
subinterfaces, this command does not clear IPv6 address mapping for the VC.
• If you specify a subinterface and a VC that is not on the subinterface, this command does not
clear IPv6 address mapping for the VC.
• If you specify only an interface, this command clears IPv6 address mapping for all VCs on the
interface.
Examples
# Clear all dynamic IPv6 address-to-DLCI maps.
<Sysname> reset fr ipv6 ind

reset fr pvc

Use reset fr pvc to clear statistics for PVCs.
Syntax
reset fr pvc [ interface interface-type interface-number [ dlci dlci-number ] ]
Views
User view
Predefined user roles
network-admin
Parameters
interface interface-type interface-number: Specifies an interface by its type and number. It can be a
main interface or subinterface. If you specify a main interface, this command clears statistics for the
main interface and its subinterfaces. If you specify a subinterface, this command clears statistics for
the subinterface. If you do not specify an interface, this command clears statistics for all interfaces.
dlci dlci-number: Specifies a VC by its DLCI in the range of 16 to 1007. DLCIs 0 through 15 and 1008
through 1023 are reserved.
Examples
# Clear statistics for all PVCs on Serial 2/1/0.
<Sysname> reset fr pvc interface serial 2/1/0

snmp-agent trap enable fr

Use snmp-agent trap enable fr to enable SNMP notifications for Frame Relay.
Use undo snmp-agent trap enable fr to disable SNMP notifications for Frame Relay.
Syntax
snmp-agent trap enable fr
352