Table of Contents
Advertisement
16.3 INSTALLING THE DTIC
The DTIC-E1 can be configured in slots A1−A6 in the Octel 200 message server and in slots A1−A11 in
the Octel 300 message server. The connectors on the Octel 200/300 use a 50-pin male telco connector.
Refer to the Installation and Maintenance volume, Installation chapter, for the DTIC pin assignment
chart.
The hardware for the ISDN installation consists of three parts:
DTIC-E1. Refer the the DTIC chapter for complete information about the DTIC.
-
Amphenol to BNC converter. A 75-ohm converter, P/N 300-6062-2011, or an Amphenol to twisted
-
pair, 120-ohm converter, P/N 300-6075-101.
Earthing/Fixing Bracket.
-
Refer to the Installation and Maintenance volume, Hardware Replacement chapter for information about
installing the DTIC.
The converter fits into the amphenol socket that corresponds with the slot contains the E1 card. Fix the
converter in place by screwing it into the earthing bracket. Make sure that the earthing bracket is fixed to
the back of the Octel 200/300 message server across the fixing screws for J2 on an Octel 200 message
server or a J4 on an Octel 300 message server.
PB60019-01
ISDN Integration
16-5
Octel 200/300
S.4.1
Advertisement
Chapters
Table of Contents
