Table of Contents
Advertisement
c.
Connect phone A to extension EXT-A. Connect phone B to extension EXT-B. The message
waiting indicator on phone B must be OFF before proceeding with testing. If the indicator is
flashing, cancel the message waiting condition before continuing.
d. From phone A, enter the extension number of the first MIC port. Does the Superset ring?
NO
e.
Answer the call on the Superset, and verify the circuit quality. If the quality is bad, determine the
cause and correct the problem.
f.
Press the TRANS/CONF softkey (this should appear as softkey 3) to initiate a transfer. If the
softkey does not appear, the Superset extension may be configured incorrectly in the PBX
configuration. Correct the problem before continuing.
g. Check for stutter or solid dial tone after pressing the softkey. If neither is present, correct the
problem before continuing.
h. Enter the extension number of phone B. After several ringbacks have occurred (less than the
PBX configured number of ringbacks before ring-no-answer forwarding), press the CANCEL
softkey (this should appear as softkey 5) to reconnect to phone A. Does phone B stop ringing?
Do you get reconnected to phone A, which was on hold?
NO
i.
Hang up phone A and the Superset 4. Connect the Superset 4 to the next Octel 200/300 MIC port
extension and repeat steps d. through h. until every MIC port extension has been tested.
3. DISPLAY TEST FOR DIRECT CALLS
This test verifies that the MIC ports receive the proper display information from the PBX for
direct internal and direct external calls.
a.
Using phone A, call out of the PBX and back in on the trunk that terminates at the Superset 4.
b. Look at the Superset 4 display. The display should contain this information:
TXXX CALLING
XXX is the trunk number.
If the display does not contain this information, determine the cause and correct the problem
before continuing.
c.
Hang up phone A.
d. Using phone A again, enter the extension number of the Superset 4.
e.
Look at the Superset 4 display. The display should contain this information:
XXX CALLING
XXX is the extension of phone A.
If the display does not contain this information, determine the cause and correct the problem
before continuing.
f.
Hang up phone A.
PB60019-01
Determine the cause and correct the problem before continuing.
'
Determine the cause and correct the problem before continuing.
'
Mitel SX-200 Digital Adaptive Integration
Octel 200/300
10.1-27
S.4.1
Advertisement
Chapters
Table of Contents
