Table of Contents
Advertisement
8.1-24 Integration Volume
f.
After a short interval does the Octel 200/300 respond with, "Extension XXXX is unavailable.
Please leave a message at the tone . . ."?
YES
NO
g. While still connected to the Octel 200/300, enter MBX number YYYY.
h. Did the Octel 200/300 respond with the prompt, "Thank you. Just a moment. . ." ?
YES
NO
i.
After a short interval, does the Octel 200/300 respond with, "Extension YYYY is unavailable."
Please leave a message at the tone"?
YES
NO
13. HUNT GROUP OPERATION TEST (FOR NEW INSTALL)
Verifying the hunting sequence
.
a.
Using the terminal, at the @ prompt, enter
P S
b. Does the port status show all ports in the IDL (idle) state?
NO
.
c.
From phone A, enter the extension number or access code associated with the Octel 200/300
hunt group.
d. Does the Octel 200/300 answer properly?
NO
e.
From the terminal, at the @ prompt, enter
P S
.
Octel 200/300
S.4.1
Continue.
'
Determine the cause and correct before continuing.
'
Continue.
'
Determine the cause and correct the problem before continuing.
'
Enter
then hang up.
9
9
'
Determine the cause and correct the problem before continuing.
'
.
The terminal command P S displays the current status of each Octel 200/300 port. A
three-character abbreviation denotes the state of each port. Refer to the Installation and
Maintenance volume, Maintenance Commands chapter, for more information on using the P
S command and the meaning of the states.
Enter
Determine the cause and correct the problem before continuing.
'
Some ports may be in the TST (test) state momentarily due to online diagnostics. If a
port is in the TST state, you should enter P S several times before deciding if the port
has a problem or if selftest is running. Selftest runs every five minutes and if a problem
is encountered, it is entered in the Hardware Error Table. Refer to the Installation and
Maintenance volume, System Errors and Traffic Pegs chapter, for more information.
Determine the cause and correct the problem before continuing.
'
Enter
Port status should show the port in WFD (wait for digits) state when an incoming call is
answered.
PB60019-01
Advertisement
Chapters
Table of Contents
