Avaya Octel 200 Installation And Maintenance Manual page 851

System Communication Commands
<STX>98<CR> <LF>
98 is the command that the MD110 periodically uses to do a system check.
<STX>99<CR> <LF>
99 is the command that the message server uses to acknowledge the system check command was received
from the MD110 and completed by the message server.
If a Call Record is not Received
With Ericsson MD110 release BC 6.0 or later, the MD110 sends a call record before the message server
answers a call. However, with earlier software releases, the MD110 sends a call record after the message
server answers the call. Refer to the Configuration section in this chapter. If the message server does not
receive a call record within the configured number of rings before answering or within the configured
number of seconds after answering, the caller hears the company greeting as a default. If this occurs, check
to determine whether:
The data link is out of operation — check all connections. Once connections are verified, test to see if
-
information can successfully be sent or received over the link using a serial terminal. Place test calls
and use MON2 command to monitor the message server.
The MD110 has a configuration problem.
-
PB60019-01
MD110 Adaptive Integration 14−7
Octel 200/300 S.4.1