Avaya Octel 200 Installation And Maintenance Manual page 880

15-4 Integration Volume
15.2 OCTEL 200/300 MESSAGE SERVER CONFIGURATION
Several changes must be made to the Octel 200/300 message server configuration to accommodate the
DPNSS integration. Refer to the Configuration and Installation and Maintenance volumes for details
about configuring the message server.
To configure the Octel 200/300 message server to work with a PBX, you must make changes in UPDATE
to the System Parameter Table and the Slots Table. The following explains the type of changes that might
be required.
System Parameters
You must set several system parameters to allow the DTIC to work correctly. Refer to the Configuration
volume −
System Parameter 3 —
-
Select the PBX Type to be integrated.
System Parameter 198 —
-
Set to 1 for A-law.
System Parameter 304 —
-
This is the string in the DPNSS packet that tells the PBX to turn on message-waiting indication. It is
sent as part of a manufacturer-specific nonspecified information string. Enter 0 for none.
System Parameter 305 —
-
This is the string in the DPNSS packet that tells the PBX to turn off message-waiting indication.
Enter 0 for none.
Þ
For System Parameters 304 and 305, if the first digit in both parameters is 0, message
Important:
waiting does not use DPNSS NS1 strings; instead, the Call Back Messaging supplementary service
is used.
System Parameter 306 —
-
Enter the extension number that the message server uses as the originating line ID when originating
an outgoing call.
System Parameter 313 —
-
Enter the extension number that the message server expects to see in the Destination Address for
direct and forwarded calls to the message server. In most cases, it is the pilot number for the message
server.
.
System Parameter 314 —
-
For GPT PBX integrations, this parameter default is NO; for all other PBXs integrated with DPNSS,
this parameter should be YES. The GPT PBX sends an NSI string in the Initial Server Request to
identify IVM extensions to the message server. If this system parameter is set to NO, when a PBX
that does not have the IVM feature attempts to divert or forward an extension to the message server,
there is no confirmation.
Octel 200/300 S.4.1
SYSTEM PARAMETER TABLE
PBX TYPE and PBX MODEL
PCM ENCODING FOR THE SYSTEM
DPNSS: MESSAGE WAITING INDICATION ON STRING
DPNSS: MESSAGE WAITING INDICATION OFF STRING
DPNSS: VOICE MAIL ORIGINATING LINE ID
DPNSS: VOICE MAIL DESTINATION ADDRESS
If mailbox holders forward their telephones to the message server, system parameters 306
and 313 should be different extension numbers. Otherwise, if phone A is forwarded to
phone B and phone A calls phone A, the forwarding is overridden and phone A rings.
DPNSS: ALLOW NON-IVM USERS TO SET DIVERT TO VOICEMAIL
, for information about system parameters.
PB60019-01