Avaya Octel 200 Installation And Maintenance Manual page 633

1. PRE-OCTEL 200/300 OPERATIONAL TEST
This test verifies that dial tone is present on each PBX extension associated with the Octel
200/300 and the modular telephone sets.
a. Disconnect the 25-pair cables from the back of the Octel 200/300.
b. Connect the modular adapter to the 25-pair cable associated with slot 1.
c. Connect a 2500-type single line telephone to the first jack position of the adapter.
.
d. Go off-hook. Is dial tone present?
YES
NO
e. Go off-hook on the M2616 modular telephone (link) by pressing the DN key. Is dial tone
present?
YES
NO
2. EXTENSION NUMBER CHECK
This test verifies that PBX extension numbers match the Octel 200/300 SLOTS Table
.
a. Connect one modular adapter to the 25-pair cable associated with slot 1.
b. Label the three single line telephones telephone A, telephone B, and telephone C. Connect
telephone B to the modular adapter position associated the first port assigned to this link.
c. Connect telephones A and C to the two test telephone RJ11 jacks. Telephone C must be
connected to the test phone line, which is configured for message waiting.
d. From telephone A, enter the extension number associated with telephone B.
e. Does telephone B ring?
YES
YES
Does the LED corresponding to the port light steady?
YES
PB60019-01
For a four port line card, only the first four jack positions of the modular adapter are used
per cable.
Repeat B, C, and D for all extensions and cables for each slot
'
configured with line cards.
Determine the cause and correct the problem before continuing.
'
Repeat steps c. through e. to test all other configured links associated with
'
the SIC8 board.
Determine the cause and correct the problem before continuing.
'
Before continuing with this test, obtain a hardcopy of the SLOTS Table for reference.
' Does the LCD flash on the M1 modular telephone sets that
correspond to the Octel 200/300 port called?
' Answer the call using telephone B and verify the circuit quality.
Hang up the phone.
'
Meridian 1 Adaptive Integration
.
Octel 200/300
11-21
S.4.1