How To Configure The Dtmfint Table - Avaya Octel 200 Installation And Maintenance Manual

How to Configure the DTMFINT Table

The DTMFINT Table can be configured in two ways:
Modify System Parameter 3 — PBX TYPE, and accept the default DTMFINT Table.
-
Use the UPDATE commands ADD and DELETE.
-
After configuring the DTMFINT Table, a listing of the configuration may be obtained via the LIST
command in UPDATE.
Modifying System Parameter 3
Use the MODIFY command to establish default values for the DTMFINT Table according to the PBX
connected to the Octel 200/300. The Octel 200/300 automatically loads the default values corresponding
to the PBX selected from the list in System Parameter 3.
.M SYSP 3
a) Select the MANUFACTURER−NUMBER of your telephone system
from the following list.
MOD:20
Select the MODEL−NUMBER of your telephone system
from the following list.
.
MOD:1
Do you wish to RESET DTMFINT Table to FACTORY−DEFAULTS for
this PBX? (If "YES", ALL current values will be LOST!)
(Y/N, empty line = Y):
DTMFINT Table RESET.
Do you wish to RESET ALL SYSTEM PARAMETERS to FACTORY−DEFAULTS for
this PBX? (If "Yes", ALL current values will be LOST!)
(Y/N, empty line = Y).
MOD:
.
For message servers that are already installed, modifying System Parameter 3 does not reset
system parameters to manufacturer defaults; current values for the SYSTEM PARAMETER Table
are maintained.
PB60019-01
Enhanced DTMF In-Band Integration
Octel 200/300
3-11
S.4.1