Table of Contents
Advertisement
8.1-26 Integration Volume
15. VERIFYING TRUNK TO OCTEL 200/300 OPERATION
This step is done once the trunks have been directed to the Octel 200/300.
a.
From the terminal, at the @ prompt, enter
P S
b. Does the port status show all ports in the IDL state?
NO
c.
From phone A, call outside of the PBX and back in on a trunk dedicated to the hunt group.
d. Does the Octel 200/300 answer properly?
NO
e.
From the terminal, at the @ prompt, enter
P S
f.
Does the port that answered show WFD state?
NO
g. From phone A, enter the extension number associated with phone C. The Octel 200/300 should
respond with, "Thank you. Just a moment."
h. Does phone C ring?
NO
i.
From the terminal, at the @ prompt, enter
P S
Port status should show port 1 in the AIC (assisted incoming call/automated attendant) state.
j.
Answer phone C before it forwards on ring-no-answer. Does the Octel 200/300 transfer the
incoming trunk to phone C?
NO
k. From the terminal, verify the port state is IDL by entering at the @ prompt
P S
l.
Busy out the port that answered by entering at the @ prompt
TE C 1 x
where x is the port that just processed the call.
m. Repeat the procedure from step c. for all ports until all ports are busied out. Verify that calls can
be placed through the Octel 200/300 from each port.
Octel 200/300
S.4.1
Enter
Determine the cause and correct the problem before continuing.
'
Determine the cause and correct the problem before continuing.
'
Enter
Determine the cause and correct the problem before continuing.
'
Determine the cause and correct the problem before continuing.
'
Enter
Determine the cause and correct the problem before continuing.
'
Enter
Enter
PB60019-01
Advertisement
Chapters
Table of Contents
