Table of Contents
Advertisement
8.1-32 Integration Volume
Diagnostic
Link (1−2) Status
Integration Pegs
Octel 200/300
S.4.1
Code is downloading to the RIC.
DOWNLOAD
INITIALIZATION Serenade is downloaded to the card and setting up
operation parameters.
The RIC is operational.
CARD UP
The diagnostic code is read from the RIC card.
If there are no errors the
-
If an error is found the
-
XX.
If this happens, refer to the Installation and Maintenance volume,
System Errors and Traffic Pegs
There are four possible states for the digit display set links to the RIC:
Link operating properly. No call.
IDLE
Link is handling a call or doing message waiting
ACTIVE
indication.
The link is getting call information or commands
DOWN
from the PBX but the PBX does not recognize the
commands the RIC card is sending back over the
link.
The link is not getting call information or
DEAD
commands. The link is probably disconnected.
Only states DOWN and DEAD are error conditions. If either of these
states are found, check the PBX and the wiring.
Integration pegs are defined into two types — Link Independent and
Link Dependent. Link-Independent pegs can occur on either link, while
Link-Dependent pegs occur on the link that is pegged. Integration pegs
are listed by using the L INT command.
LINK-INDEPENDENT PEGS
PEG 1
The number of times both links were busy when
another appearance was ringing. (255 maximum)
PEG 2
The number of times uplink transmissions had to be
unlocked.
PEG 3
The number of times the trace reply buffer
overflowed.
PEG 4
Not used.
PEG 5
The number of times the LED event reply buffer
overflowed.
DIAGNOSTIC = OK.
DIAGNOSTIC = ERROR DETECTED, CODE =
.
PB60019-01
Advertisement
Chapters
Table of Contents
