Avaya Octel 200 Installation And Maintenance Manual page 477

10.1.6 MITEL SX-200 DIGITAL INSTALLATION AND TESTING
This section describes the procedures for installation and testing of Mitel Adaptive Integration for the
Octel 200/300. These tests verify that Mitel Adaptive Integration works properly with the PBX. Some of
the tests are made before the Octel 200/300 is connected to the PBX. Always check the PBX for proper
operation after any changes are made to the system. The following items are required for testing:
Quantity Description
2
1
1
1
2
1
1
2
.
During all installation and testing procedures, no other calls should be made into the Octel
200/300. If the Octel 200/300 receives other calls, the test results may be invalid.
Follow the testing procedures carefully, in the following order:
1. Configuration of test extensions
2. Testing of Mitel SX-200 Digital
3. Installation of MIC board
4. Testing of Adaptive Integration
Configuration of Test Extensions
Configure two additional analog extensions in the Mitel SX-200 Digital before performing the tests
described in the following sections. The configuration procedure for these extensions is described below.
1. Allocate two analog extensions (2500-type single line) in the PBX. The extension numbers of these
extensions must be consistent with the format of the mailbox numbers in the Octel 200/300 USER
Table. For example, the first digit and number of digits in the extensions must correspond to the
mailbox numbering scheme.
PB60019-01
Table 10.1-1 Test Equipment
2500-type, single line touchtone phones, one with a message waiting indicator.
Terminal/teleprinter directly connected to Octel 200/300 Port J1 or SP1 via RS-232C
cable.
Hard copy of the Octel 200/300 configuration database.
Hard copy of the PBX configuration.
Single line analog extensions, connected to RJ11 jacks for testing.
Individually addressable trunk line into the PBX.
Mitel Superset 4 display phone. This phone is required for testing purposes only. It is
used to emulate the MIC board.
Modular adapters for 2500-type and Superset 4 extensions. Armiger AA2560A or
equivalent are recommended.
Mitel SX-200 Digital Adaptive Integration
Octel 200/300
10.1-23
S.4.1