Table of Contents
Advertisement
The integration links require M1 modular telephone sets, which are supported by M1 digital interface
-
card, NT8D02AA.
One pair of wires connect the digital interface card to the modular telephone (M2616).
Each modular telephone requires 26 volt AC power.
-
.
It is recommended that the eight digital display links be on two different NT8D02AA cards in the
M1 for enhanced reliability.
The SIC8 can be configured in slots A1-A11. It cannot be plugged into A12. For any release level,
the SIC8 must be plugged into its configured slot.
Cables. One RS-232C DB25 connector per modular telephone. (Supplied by the PBX vendor.)
Software Requirements
The following M1 software is required for the installation:
Issue. Generic X11 software (issue). Options 11, 21, 61, 71
Release. 14 or later.
Options Required in Package.
10 — Enhanced End to End Signaling (EES)
This option allows M1 digital telephones to send DTMF digits.
18 — Special Services for 2500 Set Features (SS25)
This option allows touchtone forwarding of Octel 200/300 ports (2500 sets).
19 — Digit Display (DDSP)
This option allows call information to appear on the M1 digital display telephones.
46 — Message Center (MWC)
This option allows the SIC8 to turn telephone message waiting indicators ON and OFF.
88 — Digital Set (DSET)
This option allows the use of digital telephone sets.
170 — Meridian Modular Telephone Set (ARIE)
This option allows the use of Meridian modular telephone sets.
PB60019-01
The M2616 telephone sets perform a selftest that sounds like the phone is periodically going
off hook.
The SLIC should only be plugged into slot 4 in the D.I.A.L. cabinet.
Meridian 1 Adaptive Integration
Octel 200/300
11-5
S.4.1
Advertisement
Chapters
Table of Contents
