Table of Contents
Advertisement
Trunk Group Configuration
Any incoming CO trunk group answered by the Octel 200/300 must have its incoming destination defined
to be the Octel 200/300 hunt group. All incoming trunk groups carrying calls that could be directed or
re-directed to the Octel 200/300 must be named using the format required for identification by the Octel
200/300.
Configure the trunk group as follows, and check each step when complete. A configured screen example
follows the steps.
1. List the DEFINITY G3 trunk groups. Note those which are to be answered
directly by the Octel 200/300.
2. Use the CHANGE command to modify one of the trunk groups. Figure 12.1-9
shows an example of the Trunk Group data entry screen.
3. Change the trunk group's name to fit this format:
T-XXX
where XXX is the trunk group's number.
4. If the trunk group is to be answered directly by the Octel 200/300, enter EXTNH
for the Incoming Destination. Also write down the Group Number and
the TAC. These numbers are needed for the Octel 200/300 configuration.
5. Repeat steps 2 through 4 for each trunk group listed in step 1.
Group Number: __
Group Name: T-XXX
Direction: __________
Dial Access? _
Queue Length: ___
Prefix-1? _
TRUNK PARAMETERS
Trunk Type: ____________
Outgoing Dial Type: ________
Trunk Termination: ______
ACA Assignment? _
Short Holding Time(secs.): ____
Answer Supervision Timeout: ______
PB60019-01
TRUNK GROUP
Group Type: __
COR: __
Outgoing Display? _
Busy Threshold: __
Restriction: ____
Figure 12.1-9 Trunk Group Data Entry Screen
Definity G3 Adaptive Integration with APIC
Page 1 of
SMDR Reports? _
TAC: XXX
Data Restriction? _
Night Service:
Incoming Destination:EXTNH
Digit Absorption List: _
Disconnect Timing(msec): ____
Long Holding Time(hours): ___
Short Holding Threshold: ___
Maintenance Test? ___
Suppress # Outpulsing? ____
12.1-17
n
____
____
____
____
Octel 200/300
S.4.1
Advertisement
Chapters
Table of Contents
