Installing the DTIC−E1 CARDS
Start subheading here
PB60019-01
Appendix A Mitel SX2000 Integration (DPNSS)
Refer to the installation instructions for additional information.
1. Check that the system is running S3.0 or higher (if it is
not, an upgrade is required first. STOP!)
2. List ALL and capture to a PC for reference.
3. Print DTMFINT table, Application Delays and SLOTS
Tables.
4. Remove analogue line card(s) from the Slots Table.
5. Replace analogue line card(s) with digital E1 card.
6. Set up system parameters.
7. Check and modify the Application Delay Table.
All table setup and modifications must be done in an UPDATE
section logged in with the maintenance password.
The Hardware for the DPNSS installation consists of three
parts:
DTIC−E1
G
Amphenol to BNC converter
G
Earthing / Fixing Bracket
G
The DTIC card can be installed in any of the slots that would
normally house an analogue or FAX card, (i.e. slots 1−6 on an
Octel 200, slots 1−11 on an Octel 300).
As with all other line cards the DTIC card can be hot plugged.
The DTIC card can be installed and configured with the server
in−service but the server will need to be rebooted with a
RESTA to activate the install.
For specific information on the DTIC card, refer to the
Installation and Maintenance Manual, Volume IV, Chapter 10.
10.3A-11
Octel 200/300
S.4.1