Table of Contents
Advertisement
b. Listen to the complete company greeting. Press
NO
c.
From phone A, call out and back in on a trunk that autoterminates at the Octel 200/300.
When the Octel 200/300 answers, let the system time out; do not enter any digits.
d. Does the Octel 200/300 transfer the call to the intercept position that was configured for this trunk
group?
NO
e.
If different intercept positions are defined for each trunk group, repeat steps a through d for each
group.
10. MESSAGE WAITING FOR SYSTEMS USING THE Octel 200/300 TO CONTROL MESSAGE
WAITING INDICATION
Use this test to verify correct operation of message-waiting indication for systems using MWI.
a.
Take phone B off-hook so that it appears busy.
b. From phone A, call out and back in on a trunk autoterminated at the Octel 200/300.
c.
Does the Octel 200/300 answer correctly?
NO
.
d. Call the extension number of phone B. Does the Octel 200/300 respond with "Extension EXT-B is
busy. Please leave a message at the tone, enter another extension number, or press zero for
assistance" ?
NO
e.
Leave a test message for phone B.
.
NO
f.
From phone B, call the Octel 200/300 and enter mailbox B. The Octel 200/300 should respond with
"You have one message. Ready."
g. Listen to the test message.
h. Press
"One message will be erased. . . "?
i.
Press
NO
j.
Hang up phone B. Is the message-waiting indicator turned OFF?
NO
PB60019-01
Determine the cause, and correct the problem before continuing.
'
Determine the cause, and correct the problem before continuing.
'
Determine the cause, and correct the problem before continuing.
'
You might prefer to use the Quick Message feature to leave a message for phone B instead of
following the instructions in step d and e.
Determine the cause, and correct the problem before continuing.
'
A message is not delivered to a mailbox unless it is at least 4.5 seconds long. Leave a test
message that is approximately 15−20 seconds long to ensure that it is a valid message. The
mailbox number for phone B must be entered in the Octel 200/300 USER Table or the Octel
200/300 does not offer to take a message.
Determine the cause, and correct the problem before continuing.
'
to erase the message. Press
3
to exit the system. Does the Octel 200/300 respond with "Good-bye. . . "?
9
Determine the cause, and correct the problem before continuing.
'
Determine the cause, and correct the problem before completing the test.
'
Northern Telecom Adaptive Integration with NPIC
. Did you reach the correct intercept position?
0
to exit the mailbox. Does the Octel 200/300 respond with
9
13-31
Octel 200/300
S.4.1
Advertisement
Chapters
Table of Contents
