Table of Contents
Advertisement
10.1-16 Integration Volume
EXTN — Assign any available extension numbers. Make a note of the extension numbers; they will
be needed for defining the MIC port hunt group, SLOTS Table in the Octel 200/300, and also for the
Installation and Testing procedures.
COS — For MWI, assign one extension the COS defined for MWI in the COS definition above.
Assign the remaining extensions the COS defined for CPI.
COR — Assign each extension a COR enabling the extensions to make all outcalls required for
normal operation.
TYP — Program this entry to SET for each MIC extension indicating that the extension is for the
Superset.
ANNOUNCE — Leave these entries blank.
BLF — (Generic 1001 and Generic 1002 only) This field is not used and is left blank.
NAME — (Generic 1003 only) Leave this entry blank for the MIC extensions.
ASSOC — Leave this entry blank.
COMMENTS — Fill this entry with any desired information.
5. Use the EXPAND SET function to display the CDE form for programming each Superset's line keys.
Check that only key 01, the Prime Line, is enabled on this form. The entries for all other keys should
be blank.
6. (CPI only) Using CDE form 17, HUNT GROUPS, create a hunt group that includes all of the MIC
port extensions used for call processing. If this is an upgrade of an installed Octel 200/300, use the
existing Octel 200/300 port hunt group, but be sure to remove all of the old Octel 200/300 port
extensions from the hunt group. Otherwise, allocate a new hunt group. Program the hunt group as
follows:
ACCESS CODE — Allocate a convenient access number to be used to call the Octel 200/300. Enter
it as the hunt group access code.
OVERFLOW — (Generic 1003 only) Enter the extension number of the fail-safe position where
calls will be directed if all Octel 200/300 ports are busy.
HUNTING (TERMINAL/CIRCULAR) — Define the hunt group to be circular.
HUNT GROUP TYPE — Enter STN/SET for the hunt group type.
HUNT GROUP NAME — (Generic 1003 only) Enter a name for the hunt group or, if no name is
desired, leave this entry blank.
EXTENSION NUMBERS — Enter all of the extension numbers of the MIC ports used for CPI. Do
not include the extension used for MWI or any other extension.
7. (MWI only) Using CDE form 17, HUNT GROUPS, create a hunt group that includes all of the MIC
port extensions used for message waiting indication. Program the hunt group as follows:
ACCESS CODE — No access code need be entered for this hunt group.
OVERFLOW — No access code need be entered for this hunt group.
HUNTING (TERMINAL/CIRCULAR) — Define the hunt group to be circular.
HUNT GROUP TYPE — Enter STN/SET for the hunt group type.
Octel 200/300
S.4.1
PB60019-01
Advertisement
Chapters
Table of Contents
