Table of Contents
Advertisement
8.1-18 Integration Volume
4. PORT RINGING TEST
This test verifies that the appearances of the Octel 200/300 ports on the RIC links have been
configured for No Ring.
a.
Connect the display phone to the jack position of the modular adapter associated with Link 1 on
the RIC board.
b. From phone C, call the extension number associated with the Octel 200/300 port 1. Does the
port appearance LED flash on the display phone?
NO
c.
Lift the handset of the display phone. Does the call get answered?
YES
d. Continue the test by calling from phone C to the next Octel 200/300 port extension number and
perform step c. again.
e.
When each Octel 200/300 port has been tested for Link 1, connect the display phone to Link 2
and repeat the test.
f.
Repeat the sequence for Integration Unit 2, Links 1 and 2.
5. PBX BUSY FORWARD TEST
This test verifies that a call to a busy extension forwards to the Octel 200/300 hunt group
a.
Connect phone B to the modular adapter position associated with port 1 of the Octel 200/300.
b. Make phone C busy by taking it off-hook.
c.
From phone A, call the extension number associated with phone C.
d. Does phone B ring immediately?
NO
e.
Answer phone B. Verify talk path and voice quality. Hang up.
6. PBX RING-NO-ANSWER FORWARD TEST
This test verifies that a call to a ring-no-answer extension forwards to the Octel 200/300 hunt
group
a.
Connect phone B to the modular adapter position associated with port 1 of the Octel 200/300.
b. From phone A, call the extension number associated with phone C.
c.
Does phone C ring?
NO
Octel 200/300
S.4.1
Check the PBX configuration and try again.
'
The Octel 200/300 port is incorrectly configured as ringing. Change the PBX
'
configuration for the display phone RIC link so that the Octel 200/300 port is
configured as No Ring.
Determine the cause and correct the problem before continuing.
'
.
Determine the cause and correct the problem before continuing.
'
.
PB60019-01
Advertisement
Chapters
Table of Contents
