Avaya Octel 200 Installation And Maintenance Manual page 599

Configuring the Mitel SX−2000 Light to Integrate
System Configuration
Link Descriptor Assignment
Digital Link Assignment
PB60019-01
Appendix A Mitel SX2000 Integration (DPNSS)
Refer to the Mitel SX2000 manual, section 9125−070−610 NA,
for details on the Mitel SX2000 with DPNSS configurations.
Follow the sequence listed below for an organized approach
when implementing DPNSS on the Mitel SX200. The Form
Group choice for each screen is indicated in parentheses
following the screen itself.
CONFIGURE THE MITEL PBX TO INTEGRATE
1. System Forms System Configuration
2. Digital Link Forms Link Descriptor Assignment, Digital
Link Assignment, Network Syn-
chronization (optional)
3. Trunk Forms MSDN/DPNSS − DASS II Trunk
Circuit Description, Trunk Assign-
ment, Trunk Services Assignment,
Trunk Group Assignments
4. Automatic Route Digital Modification Assignment,
Selection Forms Route Assignment, Automatic
Route Selection (ARS) Assignment
PBX Configuration Screen Samples for DPNSS Integration
Cabinet Shelf Slot
3 1 2
(System Configuration Form)
Program the DPNSS Link to operate in A or B mode. Use
default settings for fields not specifically shown below.
Description
Address for Message Control
(A/B)
Integrated Digital Access
Link Descriptor Assignment Form (Digital Link Forms)
Cabinet Shelf Slot Link Card
Descrip-
tor
3 1 2
Digital Link Assignment Form (Digital Link Form)
Programmed Installed Card
Card Type Type
CEPT CEPT
Formatter Formatter
Value
A
DPNSS
Digital
Type Link Number
1 CEPT 1
For-
matter
Octel 200/300
10.3A-3
Text
A
S.4.1