Customer Telephones - Avaya Octel 200 Installation And Maintenance Manual

The following SL-1 specific configuration commands might vary between systems. The keys 0, 1, 2, 4
and 9 must be configured as outlined in Table 6-1. The other keys are intended as a guide, not necessarily
the only way to do the configuration.
The SL-1 commands required in the configuration for both digit display set extensions are shown in the
following table. These commands configure the keys into the correct locations.
Key #
00
01
02
03
04
(05-08)
09
10-17
18-19
20-27

Customer Telephones

With integration, mailbox and extension numbers must match for the system to operate properly. Those
that do not match will not be integrated.
Telephones with assigned mailboxes that want secondary answering of calls should be forwarded to the
pilot number of the hunt group. This allows complete integration of both internal and external calls.
However, if internal callers want the ability to use the Ring Again feature (camp-on) on a busy extension,
the SL-1 should be programmed not to forward internal calls on a busy condition. Internal callers may
PB60019-01
Table 6-1 SL-1 Extension Configuration Commands
Command Description
scn XXXX Single-call non-ring. The link extension number
(PDN) XXXX = extension number. Must be unique
extension number not used anywhere else. All links
must be different.
mik Message indicate key. Used to turn ON message
waiting indicators.
mck Message cancel key. Used to turn OFF message
waiting indicators.
NC Not configured.
dsp Digit display. Allows the phone to look at call infor-
mation without answering the call.
Not configured.
rls Release key.
scn XXXX Single call non-ring. This is the Octel 200/300 1-8
appearance. Line 1 must be configured at key 10
with successive ports configured on successive keys.
XXXX = extension of port appearance.
NC Not configured.
scn XXXX Single-call non-ring. This is 9-16 appearance. Line
9 must be configured at key #20. XXXX = exten-
sion of the Octel 200/300 port appearance.
Northern Telecom SL-1 Adaptive Integration
Octel 200/300
6-11
S.4.1