Avaya Octel 200 Installation And Maintenance Manual page 232

7.2-36 Integration Volume
9. MESSAGE WAITING INDICATOR TEST
This test verifies that a message waiting indicator can be set and cleared using the LWC feature
keys on the 7407D.
a.
b. Connect the digital phone to the first jack position of the adapter that corresponds to the first
c.
d. Enter the extension number of phone B, then hang up. Is phone B's message waiting indicator
e.
f.
10. DISPLAY TEST FOR DIRECT CALLS
This test verifies that ATTIC links receive the proper display information from the System 75
for direct internal and direct external calls.
.
a.
b. Connect one digital phone to the jack position of the adapter that corresponds to Integration
c.
d. Press the Inspect Mode key to look at the displays on the ringing line on the digital phones.
Octel 200/300 S.4.1
Connect the 356A modular adapter to the 25-pair cable associated with the slot that contains
links configured for lamp message waiting.
link configured for lamp message waiting.
Go off hook on Line 10 and press LWC−STORE key. Does the green lamp come ON steady?
NO Check the feature button assignment. Refer to Figure 7.2-5.
'
ON?
NO Check the feature options, LWC Reception. Refer to Figure 7.2-13.
'
Go off-hook on Line 10 and press feature key 2, then enter the extension number associated
with phone B. Hang up. Is phone B's message waiting indicator OFF?
NO Check the feature options. Refer to Figure 7.2-13.
'
Does the green lamp go on steady?
NO Check the feature button assignment. Refer to Figure 7.2-13.
'
Repeat steps a. through e. for all links configured.
The PBX information appears on the second line of the 7407D display. Pay no attention to
the first line of the display.
Connect the 356A adapter to the 25-pair cable associated with the configured slot.
Unit 1, Link 1, and connect the second digital phone to the jack position that corresponds to
Integration Unit 1, Link 2.
Using phone A, call out of the PBX and back in on a trunk which auto-terminates to the Octel
200/300
The second line of the display should contain this information:
a = T−XXX to A−YYY
T-XXX is the group name of the trunk group the call came in on. A-YYY is the extension of
the ATTIC hunt group.
If the display does not contain this information, determine the cause and correct the problem
before continuing.
PB60019-01