Avaya Octel 200 Installation And Maintenance Manual page 863

MD110 Configuration Checklist
The steps to the MD110 configuration are listed below. When the step is complete, put a check mark in the
n column.
1. Modify System Parameter 51 —
WITH PBX
2. Modify System Parameter 77 —
MOMENTARY DISCONNECT
3. Modify System Parameter 2 —
according to the instructions in the message server
configuration for MD-110 Voice Mail Integration.
4. Modify System Parameter 83 —
NEW MESSAGE
5. Assign COS Attribute 9 —
MESSAGE WAITING
activate message waiting lamps or message waiting dial
tone.
6. Modify System Parameter 13 —
CODE
-
-
-
-
-
7. Modify System Parameter 99 —
ANSWERING CX PORT
-
-
8. Modify System Parameter 100 —
ANSWERING MX PORT
-
-
9. Modify System Parameter 117 —
ANSWERING AX PORT
-
-
PB60019-01
, to YES.
to NO.
to YES.
LAMP OR DISPLAY PHONE
only to mailboxes that will use MWI to
. Make sure the settings are as follows:
TRANSFER INITIATE CODE:
RECONNECT AFTER NO ANSWER:
RECONNECT AFTER BUSY:
RECONNECT AFTER FAST BUSY:
TRANSFER COMPLETE CODE:
.
Set to 3 if the MD-110 sends call records before answer.
Set to 0 if the MD-110 sends call records after answer.
.
Set to 3, if the MD-110 sends call records before answer.
Set to 0, if the MD-110 sends call records after answer.
.
Set to 3 if the MD-110 sends call records before answer.
Set to 0 if the MD-110 sends call records after answer.
RS-232 INTEGRATION
PBX PROVIDES
SYSTEM ID NUMBER
LIGHT LAMP ON EACH
TRANSFER INITIATE
FE
F
F
F
ONE
N
RINGBACKS BEFORE
RINGBACKS BEFORE
RINGBACKS BEFORE
MD110 Adaptive Integration 14−19
Command
n
.M SYS 51
.M SYS 77
.M SYS 2
.M SYS 83
.A COS
.M SYS 13
.M SYS 99
.M SYS 100
.M SYS 117
Octel 200/300 S.4.1