Table of Contents
Advertisement
12. HUNT GROUP OPERATION TEST (For new install)
Verifying the hunting sequence
.
a.
b. Does the port status show all ports in the IDL (idle) state?
c.
d. Does the Octel 200/300 answer properly?
e.
f.
g. From telephone A, press
h. Busy out the PBX extension identified in step f. above by typing at the @ prompt
i.
PB60019-01
The terminal command PS displays the current status of each Octel 200/300 port. A three
character abbreviation denotes the state of each port. Refer to the Installation and
Maintenance volume, Maintenance Commands, for more information on using the PS
command and the meaning of the states.
Using the terminal, from the system level @ prompt, type
PS
NO
Determine the cause and correct the problem before continuing.
'
.
Some ports may be in the TST (test) state momentarily due to online diagnostics. If a
port is in the TST state, enter PS several times before deciding if the port has a
problem or if selftest is running. Selftest runs every five minutes and if a problem is
encountered, it is entered in the Hardware Error Table. Refer to the Installation and
Maintenance volume, System Errors and Traffic Pegs chapter, for more information.
From telephone A, enter the extension number or access code associated with the Octel
200/300 hunt group.
NO
Determine the cause and correct the problem before continuing.
'
From the terminal, at the @ prompt, enter
PS
.
Port status should show the port in WFD (Wait For Digits) state when an incoming call
is answered.
Did the correct port answer, based upon how the PBX is programmed for hunting groups?
NO
Determine the cause and correct the problem before continuing.
'
9
TE C 1 x
Enter
where x is the port indicated in step f.
Continue the process from step c. until all ports have been busied out.
Northern Telecom SL-1 Adaptive Integration
.
and hang up after the system says "good-bye."
9
6-25
Octel 200/300
S.4.1
Advertisement
Chapters
Table of Contents
