Avaya Octel 200 Installation And Maintenance Manual page 302

7.3-48 Integration Volume
Item Description
1. Forward the ports.
2. Plug the card into the configured slot . Refer to the power-
on routine and monitor the LEDs.
3. Plug the 25-pair cable into the ATTIC slot. Monitor the
LEDs.
Item Description
1. Mailbox and extension numbers must match.
2. Modify System Parameter 3 (PBX type is System 85).
3. Modify System Parameter 85 to be NONE (reconnect code
after third party disconnect).
4. Modify System Parameter 116 to be .
5. Modify System Parameter 117 to be 5 (ringbacks before
answering).
6. Add Attribute 15 to the COS of all mailboxes associated
with extensions that forward to the Octel 200/300.
7. All ports should be configured in AX mode.
8. Add a COS with Attribute 58 to those ports that do not
require integration.
9. Configure the TRUNK GROUP Table if different require-
ments than for a port. A unique COS should be assigned
for these trunks.
10. For mailboxes requiring Quick Greeting Activation,
modify INFORMATION Table Index 25 to be YES.
11. Configure all Octel 200/300 ports YES for outcall.
12. For collocated system, modify System Parameter 130 to
YES.
Octel 200/300 S.4.1
Table7.3-9 Installing the ATTIC Board
Table7.3-10 Configuration Changes to CPI
Command Complete
@ TE C 1
Command Complete
.M SYS 3
.M SYS 85
.M SYS 116
.M SYS 117
.A COS
.M SLOT
.A COS
.A TRUNK
.M INFO
Index 25
.M SLOT
.M SYS 130
PB60019-01