Avaya Octel 200 Installation And Maintenance Manual page 579

External Call Forwarded on Always Reroute
g. Using phone A, call out of the PBX and back in on the test trunk. Does the call forward to the
Superset 4?
NO
h. Look at the Superset 4 display. The display should contain this information:
CFFM:
XXX is the extension of phone B.
NO
i. Press the display feature button on the Superset 4. The display should now contain this
information:
DISPLAY . . .
If the display does not contain this information, determine the cause and correct the problem
before continuing.
j. Now press the Superset 4 prime line key. The display should contain this information:
CALLER:
XXX is the trunk number.
If the display does not contain this information, determine the cause and correct the problem
before continuing.
k. Press the EXIT softkey on the Superset 4. Hang up phone A. Change phone B's Call Rerouting
Always Alternative back to No Reroute for all types of calling devices.
11. CALLS TO THE INTERCEPT EXTENSION (ATTENDANT) (For new installation only)
This test verifies that each Octel 200/300 port extension can transfer a call to the intercept
extension (attendant).
a. Connect the Superset 4 phone to the 25-pair cable of the PBX extension used for the first MIC
port.
b. Wait for the PBX to initialize the Superset 4. This may take as long as 30 seconds. Once the set
is initialized, the display should show the time and date. If the display does not show the time
and date within 30 seconds of connecting the phone, correct the problem before continuing. If
the display contains information other than the time and date, lifting the Superset handset
off-hook and replacing it may correct the problem.
c. From phone A, call the extension number of the Superset.
d. Answer the Superset. Transfer phone A to the attendant by pressing the TRANS/CONF softkey,
pressing
e. Connect the Superset to the 25-pair cable of the next MIC port extension and make sure the
phone initializes and displays the time and date. Repeat steps b. through d. for each MIC port
until every MIC port has successfully transferred a call to the attendant.
The PBX testing is now complete. Proceed with installation of the MIC board(s).
PB60019-01
Determine the cause and correct the problem before continuing.
'
XXX
Determine the cause and correct the problem before continuing.
'
TXXX
, and the HANG UP softkey. Does phone A get connected to the attendant?
0
NO Determine the cause and correct the problem before continuing.
'
Mitel SX-2000 Adaptive Integration
Octel 200/300
10.3-35
S.4.1