Table of Contents
Advertisement
f.
Did the correct port answer, based upon how the PBX is programmed for hunting groups?
NO
g. From phone A, press
h. Busy out the PBX extension identified in step f. above by entering at the @ prompt
TE C 1 x
where x is the port indicated in step f.
i.
Continue the process from step c. until all ports have been busied out.
14. TESTING FAIL-SAFE OPERATION
All Ports Busy
a.
While all ports are busied out, use phone A to call the extension number or access code of the
hunt group.
b. Does the call overflow to the correct answering extension as determined for fail-safe operation?
NO
c.
Remove the busy condition from all Octel 200/300 port PBX extensions by entering at the @
prompt
TE C 2
Port Ring-No-Answer.
d. Disconnect all 25-pair cables associated with Octel 200/300 ports.
e.
From phone A, enter the hunt group extension number or access code associated with the
extensions connected to the Octel 200/300.
f.
Does the call divert to the correct alternate answer point when the Octel 200/300 does not
answer?
g. Reconnect the 25-pair cablesmodular line cordsOctel 200/300.
h. From phone A, enter the hunt group extension number or access code.
i.
Does the Octel 200/300 answer correctly?
NO
j.
From the terminal, at the @ prompt, enter
P S
k. Verify that all ports are in the IDL state. If any ports still show FWD, use TE C 2 x, where x is
the port number to cancel forwarding. If cancel forwarding does not work, determine the cause
and correct before continuing.
PB60019-01
Determine the cause and correct the problem before continuing.
'
and hang up after the system says "good-bye."
9
9
.
Determine the cause and correct the problem before continuing.
'
Enter
Determine the cause and correct before continuing.
'
Enter
Rolm CBX Adaptive Integration
Octel 200/300
8.1-25
S.4.1
Advertisement
Chapters
Table of Contents
