Table of Contents
Advertisement
Port COS
SLOTS Table
System Parameters
PB60019-01
AT&T System 75/Definity G1 Adaptive Integration
COS Attribute 58 — DO NOT USE THIS PORT FOR
INTEGRATION
Assign this COS attribute to those the Octel 200/300 ports used in
special applications that do not require integration.
The SLOTS Table is used to configure both Line Interface Cards (LICs)
and Integration Cards.
Line Interface Cards
ANSWERING MODE — With AT&T System 75 Adaptive Integration,
all ports can be configured for AX answering mode to maximize
utilization of the Octel 200/300 ports.
CONFIGURATION OF PORTS FOR OUTCALL — To maximize
system performance and port usage, all the Octel 200/300 ports should
be configured for outcall. If this is not possible, the higher numbered
ports should be configured for outcall. For example, in an eight-port
system, ports 3−8 should be configured for outcall.
All ports defined as YES are used for outcalls, with no restrictions.
Integration Cards
Configure each unit of each integration card, as needed, for the
following:
Card Type
-
Integration Unit Number
-
Integration
-
Assign all ports to be integrated as line appearances for all units
doing call processing.
Assign links for message waiting indication. Refer to Changes for
message waiting indication section.
Refer to the Configuration volume, Slots Table chapter, for further
information on configuring the SLOTS Table.
System Parameter 3 — PBX MODEL
Select the model number of the telephone system (System 75).
System Parameter 85 — RECONNECT CODE AFTER 3RD
PARTY HUNG-UP.
System Parameter 85 —
RECONNECT CODE AFTER 3RD PARTY
HUNG-UP.
System Parameter 116 — SHOULD INTEGRATION BE
ACTIVATED?
Modify System Parameter 116 to be YES.
7.2-27
Octel 200/300
S.4.1
Advertisement
Chapters
Table of Contents
