Table of Contents
Advertisement
6-14
Integration Volume
INFORMATION Table
SLOTS Table
System Parameters
Octel 200/300
S.4.1
INFORMATION Table Index 25 — QUICK GREETING
ACTIVATION
Modify INFORMATION Table Index 25 to YES to allow selected direct
internal callers to be able to change and turn ON/OFF their personal
greetings without first entering their mailboxes.
The SLOTS Table is used to configure both Line Interface Cards (LICs)
and Integration Cards.
Line Interface Cards. ANSWERING MODE — With SL-1 Adaptive
Integration, all ports can be configured for AX answering mode to
maximize utilization of the Octel 200/300 ports.
CONFIGURATION OF PORTS FOR OUTCALL — To maximize
system performance and port usage, all Octel 200/300 ports should be
configured for outcall. If this is not possible, the higher numbered ports
should be configured for outcall. For example, in an eight-port system,
ports 3−8 should be configured for outcall.
.
If more than eight ports are configured, the Octel 200/300 makes
outcalls when at least three ports are idle. If eight ports or less are
configured, at least two ports must be idle.
Integration Cards. Configure each unit of each integration card, as
needed, for the following:
Card Type
-
Integration Unit Number
-
Integration (message waiting links and/or line appearances for call
-
processing)
Refer to the Configuration volume, Slots Table chapter, for further
information on configuring the SLOTS Table.
System Parameter 85 — RECONNECT CODE AFTER THIRD
PARTY HUNG-UP
Modify the value of System Parameter 85 to be NONE.
System Parameter 116 — SHOULD INTEGRATION BE
ACTIVATED?
Modify the value of System Parameter 116 to be .
System Parameter 117 — RINGBACKS BEFORE ANSWERING
AX PORTS
Modify the value of System Parameter 117 to be 5. This gives the Octel
200/300 extra time to receive the call records from the PBX.
PB60019-01
Advertisement
Chapters
Table of Contents
