Avaya Octel 200 Installation And Maintenance Manual page 642

11-30 Integration Volume
f. After a short interval, does the Octel 200/300 respond with, "Extension XXX is unavailable.
Please leave a message at the tone"?
YES
NO
g. While still connected to the Octel 200/300, enter mailbox number YYY.
h. Did respond with the prompt, "Thank you. Just a moment" ?
YES
NO
i. After a short interval, does the Octel 200/300 respond with, "Extension YYY doesn't answer.
Please leave a message at the tone"?
YES
NO
13. HUNT GROUP OPERATION TEST (FOR NEW INSTALL)
Verifying the hunting sequence
.
a. Using the terminal, from the system level @ prompt, type
P S
b. Does the port status show all ports in the IDL (idle) state?
NO
.
c. From telephone A, enter the extension number or access code associated with the Octel 200/300
hunt group.
d. Does the Octel 200/300 answer properly?
NO
e. From the terminal, at the @ prompt, enter
P S
Octel 200/300 S.4.1
Continue.
'
Determine the cause and correct before continuing.
'
Continue.
'
Determine the cause and correct the problem before continuing.
'
Enter , then hang up.
' 9 9
Determine the cause and correct the problem before continuing.
'
.
The terminal command P S displays the current status of each Octel 200/300 port. A three
character abbreviation denotes the state of each port. Refer to the Installation and
Maintenance volume, Maintenance Commands chapter, for more information on using the P
S command and the meaning of the states.
Determine the cause and correct the problem before continuing.
'
Some ports may be in the TST (test) state momentarily due to on-line diagnostics. If a
port is in the TST state, enter P S several times before deciding if the port has a problem
or if selftest is running. Selftest runs once an hour and if a problem is encountered, it is
entered in the Hardware Error Table. Refer to the Installation and Maintenance volume,
System Errors and Traffic Pegs chapter, for more information.
Determine the cause and correct the problem before continuing.
'
PB60019-01