Avaya Octel 200 Installation And Maintenance Manual page 116

6-26 Integration Volume
13. TESTING FAIL-SAFE OPERATION
All Ports Busy
a.
b. Does the call overflow to the correct answering extension as determined for fail-safe
c.
Port Ring-No-Answer
d. Disconnect all associated with the Octel 200/300 ports.
e.
f.
g. Type PS at the terminal.
h. Verify that all ports are in the IDL state. If any ports still show FWD, type
14. VERIFYING TRUNK TO OCTEL 200/300 OPERATION
This step is done after the trunks have been auto-terminated to the Octel 200/300.
a.
b. Does the port status show all ports in the IDL state?
c.
d. Does the Octel 200/300 answer properly?
Octel 200/300 S.4.1
While all ports are busied out, use telephone A to enter the extension number or access code
of the hunt group.
operation?
NO Determine the cause and correct the problem before continuing.
'
Remove the busy condition from all the Octel 200/300 port PBX extensions by entering at the
@ prompt
TE C 2 x
Enter
where x is the port number.
From telephone A, enter the hunt group extension number or access code.
Does the Octel 200/300 answer correctly?
NO Determine the cause and correct before continuing.
'
TE C 2 x
where x is the port number to cancel forwarding.
If cancel forwarding does not work, determine the cause and correct before continuing.
From the terminal, enter the PS command.
NO Determine the cause and correct the problem before continuing.
'
From telephone A, call outside of the PBX and back in on a trunk dedicated to the hunt group.
NO Determine the cause and correct the problem before continuing.
'
PB60019-01