Table of Contents
Advertisement
7.2-52
Integration Volume
Item
Description
1.
List CORs currently in use on the System 75.
2.
Designate two new CORs to be exclusively for the Octel 200/300 (COR
DP & COR LK).
3.
Designate a COR to be used for the operator.
4.
Designate a COR to be used for the trunks terminating at the Octel
200/300
5.
Change the COR (referred to as COR LK). Set up COR LK; under
calling permission enter Y for all other CORs.
6.
Change COR for the Octel 200/300 ports. (Referred to as COR ΛΚΔΠ).
Set up COR LK, under calling permission enter Y for all other CORs on
the system.
7.
Change each COR on the system. Make sure calling permission is Y for
COR LK and N for COR LKDP. All other calling permission entries
should be unchanged.
8.
Verify that COR LK and COR LKDP are only used for Links,for the
Octel 200/300 ports, the operator, and on trunks terminating at the Octel
200/300.
Table 7.2-5 ATTIC Link Digital Phone Extension Checklist
Item
Description
1.
Allocate a Hunt Group pilot number to be used for access to the Octel
200/300.
2.
Add the digital stations configured for the ATTIC
3.
Set up page 1 of the Link 1 station data. Type should be 7405D.
See Figure 7.2-4.
4.
Set up page 2 of the Link 1 station data, feature button assignments.
See Figure 7.2-5.
5.
Set up page 3 of the Link 1 station data, display button assignments.
See Figure 7.2-6.
6.
Repeat for all links.
7.
Set up page 1 of Link 2 station data. "Type" should be 7405D. See
Figure 7.1-5.
8.
Set up page 2 and 3 of the Link 2 station data the same as LINK 1.
9.
Place the link extension into a hunt group. Refer to the Hunt Group
Section.
Octel 200/300
S.4.1
Table 7.2-4 Class of Restriction Checklist
Complete
Complete
PB60019-01
Advertisement
Chapters
Table of Contents
