Table of Contents
Advertisement
f.
After the duration specified by the PBX System Option for Call Forwarding Don't Answer
Time-out, does the Octel 200/300 respond with, "Extension EXT-B is unavailable. Please leave
a message at the tone. . ."
NO
g. Enter
5. INTERNAL CALL TO A BUSY EXTENSION
This test verifies that the Octel 200/300 correctly processes a call forwarded from a busy
extension.
a.
Take phone B off-hook so that it appears busy.
b. From phone A, call phone B. Does the Octel 200/300 answer with the prompt, "Extension
EXT-B is unavailable. Please leave a message at the tone. . . ?"
NO
c.
While still connected to the Octel 200/300, enter the mailbox number of mailbox B, which
should be the same as the extension number of phone B. Does the Octel 200/300 respond with
the prompt, "Thank you. Just a moment. . . ?"
NO
d. After a short interval, does the Octel 200/300 respond with, "Extension EXT-B is in use. Please
leave a message at the tone. . . ?"
NO
e.
Enter
6. EXTERNAL TRUNK CALL TO THE Octel 200/300
This test verifies that the Octel 200/300 correctly processes calls from trunks that have been
auto-terminated to the Octel 200/300 hunt group. Be sure to test all such trunk groups.
.
a.
From phone A, call outside of the PBX and back in on a trunk that auto-terminates to the Octel
200/300. Does the Octel 200/300 answer with the greeting configured for the trunk?
NO
b. From the terminal connected to the Octel 200/300, enter the PS command. Does the port that
answered show WFD state?
NO
c.
Enter
200/300 port that answered the call. Use the command
TE C 1 x
where x is the port number.
d. Repeat steps a. through c. for each Octel 200/300 port until all of the ports are busied out. This is
to confirm that each Octel 200/300 port can answer a trunk call.
e.
To release all Octel 200/300 ports from the FWD condition, from the Octel 200/300 terminal,
use the command
TE C 2
PB60019-01
Determine the cause and correct the problem before continuing.
'
to exit from the Octel 200/300 and hang up phone A.
9
9
Determine the cause and correct the problem before continuing.
'
Determine the cause and correct the problem before continuing.
'
Determine the cause and correct the problem before continuing.
'
to exit from the Octel 200/300. Hang up phone A and phone B.
9
9
1-800 (InWATS) lines can be tested individually, even if they are bands from other areas, by
using plant test numbers. Get these numbers from the CO if you do not already know them.
Determine the cause and correct the problem before continuing.
'
Determine the cause and correct the problem before continuing.
'
to exit the Octel 200/300. From the Octel 200/300 terminal, busy out the Octel
9
9
Mitel SX-2000 Adaptive Integration
Octel 200/300
10.3-39
S.4.1
Advertisement
Chapters
Table of Contents
