Avaya Octel 200 Installation And Maintenance Manual page 828

13-18 Integration Volume
Port COS
INFORMATION Table
SLOTS Table
Octel 200/300 S.4.1
COS Attribute 9 — LAMP OR DISPLAY PHONE MESSAGE
WAITING
For message-waiting indication only, assign a COS with Attribute 9 to
those mailboxes that correspond to extensions that should have
message-waiting indication.
.
The system uses the value in the Extension field of the USER
T able when it sends a message-waiting command to the Northern
Telecom switch.
COS Attribute 15 — TRANSFER TO A RINGING EXTENSION
Assign a COS with Attribute 15 to mailboxes for extensions that the M1
forwards to the Octel 200/300.
COS Attribute 58 — DO NOT USE THIS PORT FOR
INTEGRATION
Assign this COS attribute to those Octel 200/300 ports used in special
applications that do not require integration. These ports would be
supported by standard line cards rather than the NPIC cards.
INFORMATION Table Index 25 — QUICK GREETING
ACTIVATION
Modify this index to YES to allow selected direct internal callers to
change and turn ON/OFF their personal greetings without first entering
their mailboxes.
The SLOTS Table is used to configure the NPIC card. The following
describes the information to be entered for each port.
After entering the card type 52 for the NPIC card, and LSP Table must
be selected. Enter 24 for PIC_NT.
MASTER CLOCK (SYNC)—One NPIC in the message server must be
designated as the primary, to provide clock synchronization with the
PBX digital card supporting the NPIC. When more than one NPIC card
is installed in the message server, the second card is designated as
secondary; and the third card as tertiary. The remaining installed cards
are designated as NONE.
ANSWERING MODE—With M1 Adaptive Integration, configure all
ports for AX answering mode to maximize utilization of the Octel
200/300 ports.
CONFIGURATION OF PORTS FOR OUTCALL—Ports configured for
message-waiting indication are set to NO. The other ports should have
outcall set to YES. If a separate port group is designated for
networking, only the ports in that group would be set to outcall. These
PB60019-01