Table of Contents
Advertisement
f.
g. Hang up telephone C.
h. Cause telephone C to be busy by taking it off-hook. From telephone A call telephone C.
i.
j.
k. Repeat the sequence for all Integration Units and Links configured with call processing.
8. CALLS TO THE INTERCEPT EXTENSION (ATTENDANT) (For new install)
This test verifies that each port extension can transfer a call to the intercept extension
(attendant)
a.
b. From telephone A, call the extension number associated with telephone B.
c.
d. Is telephone A connected to the number entered to reach the attendant?
PB60019-01
Does the display on the SL-1 digit telephone look like this?
XXXX
=
Telephone C extension number
XXXX
NO
Determine the cause and correct the problem before continuing.
'
Repeat steps d. and e.
Does the display on the SL-1 digital telephone look like this?
YYYY XXXX
=
Telephone C extension destination number
XXXX
=
Telephone A extension source number
YYYY
NO
Determine the cause and correct the problem before continuing.
'
.
Connect telephone B to the modular adapter position associated with port 1 of the Octel
200/300.
Answer telephone B and perform a hookswitch flash, enter the transfer code, if required; press
(or the attendant's extension number). Then hang up telephone B. Use the transfer code
0
specified in System Parameter 13.
YES
Continue test for all port extensions, then proceed with step 9.
'
NO
Determine the cause and correct the problem before continuing.
'
- Before continuing with step 9 -
When all Octel 200/300 port extensions pass steps 1−8,
connect the 25-pair cables to the Octel 200/300 ports and
integration cards and test the system for standard opera-
tion. Verify that the yellow LEDs on the integration
.
To obtain the desired results, before continuing these tests, verify that all test
extensions are configured as mailboxes.
Northern Telecom SL-1 Adaptive Integration
S T O P
board are ON.
6-21
Octel 200/300
S.4.1
Advertisement
Chapters
Table of Contents
