Avaya Octel 200 Installation And Maintenance Manual page 373

Message servers
Hide thumbs Also See for Octel 200:
Table of Contents

Advertisement

9. CALLS TO THE INTERCEPT EXTENSION (ATTENDANT) (FOR NEW INSTALL)
This test verifies that each Octel 200/300 port extension can transfer a call to the intercept
extension (attendant).
a.
Connect phone B to the modular adapter position associated with port 1 of the Octel 200/300.
b. From phone A, call the extension number associated with phone B.
c.
Answer phone B and perform a hookswitch flash, enter the transfer code, and if required, press
0
d. Is phone A connected to the number entered to reach the attendant?
YES
NO
10. VERIFYING PORTS
This test verifies that all the PBX port extensions are connected to the correct Octel 200/300
ports.
a.
From phone C, call the extension associated with port 1.
b. Does the Octel 200/300 answer with "To enter your mailbox press pound"?
YES
If the Octel 200/300 does not answer, verify that the PBX port extension is connected to the
right physical Octel 200/300 port. The Octel 200/300 will not answer if the PBX port extension
is connected to the wrong physical Octel 200/300 port.
c.
On the terminal, at the @ prompt, enter
P S
The port number in the IDL2 state is the port that the Octel 200/300 thinks was called. If that is
not the port you intended to call, the lines should be changed so that the correct line is connected
to the correct port.
d. Call the same port extension number again. Go to step b.
e.
Call the extension number of the next port. Go to step b. Proceed until all ports are tested.
PB60019-01
(or the attendant's extension number). Hang up phone B.
Continue test for all port extensions, then proceed with step 10.
'
Determine the cause and correct the problem before continuing.
'
- Before continuing with step 10 -
When all Octel 200/300 port extensions pass steps 1 − 9,
connect the 25-pair cables to the Octel 200/300 ports and
integration cards and test the system for standard operation.
Verify that the yellow LEDs on the board are ON.
Go to step e.
'
Rolm CBX Adaptive Integration
S T O P
8.1-21
Octel 200/300
S.4.1

Advertisement

Table of Contents
loading

This manual is also suitable for:

Octel 300

Table of Contents