Avaya Octel 200 Installation And Maintenance Manual page 421

Message servers

Hide thumbs Also See for Octel 200:

Table of Contents

The following are definitions of the fields displayed when listing the state of the RIC board.

Link (1−2) Status

ROLM 9751 Model 30/80 Adaptive Integration

The CARD ID states the type of integration card.

There are four possible states for the card:

The RIC is down and not responding to the

Code is downloading to the RIC.

INITIALIZATION Code download is complete and the card is setting

up operation parameters.

The RIC is operational.

The diagnostic code is read from the RIC card.

If there are no errors the

If an error is found the

DIAGNOSTIC = ERROR DETECTED, CODE =

If this happens, refer to the Installation and Maintenance volume,

System Errors and Traffic Pegs chapter, for more information.

There are four possible states for the digit display set links to the RIC:

Link operating properly. No call.

Link is handling a call or doing message waiting

The link is getting call information or commands

from the PBX but the PBX does not recognize the

commands the RIC card is sending back over the

The link is not getting call information or

commands. The link is probably disconnected, or

the polarity of the tip and ring wiring is reversed.

Only states DOWN and DEAD are error conditions. If either of these

states are found, check the PBX and the wiring.

DIAGNOSTIC = OK.

Octel 200/300

Chapters

Table of Contents